Stall Without Flow

A higher angle of attack (e.g. pulling on the control stick) leads to more lift and drag, but also to lower speed. The pilot can read the speed from his instrument (also audible from the wind noise), which is the reference for him. The decisive factor, however, is the angle in relation to the flight path. To reduce the risk of a "collapse", it is therefore advisable to approach a little faster (+ half the gust speed) when landing in gusty conditions.
Increasing the angle of attack causes a forward shift and intensification of these pressure areas (see previous pages). By continuing to pull, the "pressure cushion" becomes stronger and spreads further. The "pressure deficit" increases due to the even greater drop in the backshape of the profile. But what happens if you "overpull"?
Now, at the latest, we have to look at the pressure conditions at the end of the profile. The sums of pressure energy and kinetic energy (total pressure) of the trailing edge upper side and the trailing edge lower side are out of balance. While the pressure energy increases on the underside, the kinetic energy remains almost the same and on the upper side the kinetic energy (downward direction vector) increases but the pressure energy decreases significantly. the total pressure on the underside of the profile now predominates, e.g. at the end of the profile.

Air now flows from behind around the trailing edge of the profile in the direction of flight, the pressure difference decreases - lift collapse (stall) occurs. This is not a sudden event, nor is it a complete collapse of lift. Depending on the profile, the event can happen abruptly, but it can also happen more gradually, so that the pilot notices the collapse of lift and can restore the glider to a flyable condition by immediately applying pressure (see lift diagram of corresponding profiles). Glued-on woollen threads in the stall flight test show this filling / flowing back.
Both images show the same situation. The first from the point of view of the
pressure distribution (usually invisible). The second with smoke trails in the
flow tunnel (artificially visible). Both illustrations are unrealistic.
The real movement of the pushed air particles could be shown in a sequence of images of the individual air particles. Alternatively, you can show a colored pressure distribution in which the direction vectors of the air particles (intensity by length of the arrows) are drawn. The total pressure (pressure energy + and kinetic energy) is shown on each directional arrow with a more or less large circle.
Controlled stalls (starvation - slow pull on the control stick with sufficient altitude) are generally not really dangerous if there is no spin tendency of the airplane. In uncontrolled stalls, the "collapse" usually occurs on one side, triggered by an increase in the angle of attack. Caused, for example, by turbulence (with an upward component) in speed ranges close to the lower limit or in slow turns, e.g. when turning downwind. Uncontrolled stalls must always be avoided, as they are potentially life-threatening for us normal pilots with our airplaines, except we are aerobatic pilots.
In general, pressure zones form and equalize again, regardless of the flight
condition, but equalization must not take place on the back of the profile.
Air pressure acts directly on the airfoil surface; if the pressure zones above
the airfoil equalize partially or completely, the pressure difference is reduced.
Low pressure difference = little lift.
The Mushing Flight or Sustained Stall
A ‘sustained stall’ or “mushing flight” describes the behaviour of an aircraft in which there is nearly no forward speed remaining, yet a high vertical speed is attained whilst the aircraft is in a near-horizontal attitude. The loss of speed and lift is caused by a collapse of lift (residual lift is still present – but far too low). The weight of the aircraft can no longer be supported due to insufficient lift and drag; as a result, it sinks. A stable, high rate of descent is achieved (approx. 4 m/s) at a low forward speed. The residual lift of the wing and the drag together provide a force counteracting gravity (m/s²).This is the ‘ideal case’ of lift collapse, a stable condition that pilots must deliberately maintain by continuously stalling the aircraft. One of the prerequisites is that, in this state, the rudder must be structurally capable of generating the necessary aerodynamic forces (downforce) to prevent the nose from pitching down. Not all aircraft meet these requirements. Even small differences in the lift-to-drag behaviour of the wing halves (due to the design, but also to the operation of wing flaps or control surfaces in this state) can lead to lateral pitch-out, which transitions from a mushing flight into a spiral dive. A high level of pilot skill and finesse is required to achieve a stable mushing flight.
download of the entire article
Lift on the Airfoil ⇐ | ⇒
